Featured answers
- PM180 · Battery maintenance

How do I replace the backup battery in a PM180?
The PM180 uses a CR1225 lithium 3.0 V cell. SATEC Australia recommends replacement by a qualified person during planned servicing with the instrument powered off.
Factory clarification pending on the manual's powered-change wording and replacement restart behaviour.
- EM235 PRO · Keypad

How do I set the CT ratio on an EM235 PRO?
Set EM235 PRO CT primary current from the keypad: check the input rating, open Basic Setup, enter the primary value, apply and check the saved setting.
- BFM branch feeder monitors


How do I address multiple BFM meters on RS-485 or Ethernet?
BFM136 and BFM-II: reserve non-overlapping submeter address blocks on RS-485, and use unique IP addresses on Ethernet. Checks, wiring references and manual pages.
Models: BFM136, BFM-II
- PM17x remote display


How do I check an RPM072 remote display connection?
RPM072 and RDM172 remote display: identify the connector first, then check the dedicated 15-pin or separate seven-terminal arrangement against the manufacturer drawing.
Models: RPM072, RDM172
- ETC gateways


How do I connect and configure a SATEC ETC gateway?
Configure a SATEC ETC gateway: identify the model, check serial and Ethernet settings, and test forwarding or ETC II Data Server with manual references.
Models: ETC II, ETC ONE PLUS





