SATEC offers a unique solution for Smart Grid initiatives on 10-35kV Distribution systems.
SATEC’s innovative line insulators with sensors replace the standard insulators and incorporate a built-in CT and PT function. These sensors can easily be installed without having to de-energize or cut and terminate the main line wire. They produce a very small voltage signal instead of the normal 120 Volt and 5 Amp outputs of standard CTs and PTs.
Special inputs have been designed into the SATEC Model PM174/PM175 Power Quality & Energy Meter to fully interface with the low level sensor outputs for line voltage and current. Full measurements and data can be obtained from the PM174/5, including waveforms and harmonics. A custom SATEC enclosure for the PM174/5 input connections and a GPRS modem for real-time data communication direct to a SCADA System, make installation simple.
These sensors can easily be installed without having to de-energize or cut and terminate the main line wire.
Instead of the normal 120 Volt and 5 Amp outputs of standard CTs and PTs.
Provide power quality information from remote locations that were previously unobtainable.
Deliver the power needed by the system during high demand periods.
By enhancing the input design of the standard PM174/5 Power Quality & Energy Meter to accept the low level signals provided from the sensors, SATEC has provided the utility Industry with a new powerful system to monitor, coordinate and operate distribution systems in a real-time mode to provide power quality information from remote locations that were previously unobtainable.
The Utility can now process this information to analyze power flow and determine MW-reduction capabilities. They can use this data to execute commands to operate and control equipment such as voltage regulators, capacitor controls, loading switches and system outage reporting. Today, this information is usually limited to just what the voltage regulators can provide from their single source of regulation, which has been deemed insufficient. The need is to increase monitoring to additional points further “downstream” of the regulator to many critical points along the grid.
SATEC’s approach can control demand reduction during peak load times to deliver the power needed by the system during high demand periods. This can help minimize losses on the distribution system and optimize efficiency as well as the quality of the power.
SATEC’s device product line serves both energy utilities and energy consumers in various fields. Our application-based product line includes devices spanning from basic power meters up to high performance revenue meters with advanced power quality capabilities.
